Display Instruction

1.Under standby mode, double-click watch screen to start the LED display.

2. Lighted LED with clockwise display represents the current time. The glitter of hour point shows the current hour, The accumulation in sequence of minute point shows the current minutes.

Time Setting

1. Hold the watch screen 5 seconds in the time showing state.  LED at the clock position is flashing and the watch is into the state of the clock setting. At this time, click the screen to modify the current hour parameters. Press on the screen and LED will quickly and continuously glitter.

2. After setting the hour, wait for 5 seconds. Minutes LED flash and the watch is into the state of minutes setting. Click the screen to modify the current parameters. Press on the screen and LED will quickly and continuously glitter.

3.After setting the correct minute parameter, then the timer will assure the current time and be into the state of time display after 5 seconds.

The sensitivity about touching the screen

the bigger the contact area of the finger and the screen is, the higher the sensitivity of receiving sensor is.

Note:  When you don’t use the watch, please don’t press the screen, which can save the battery power consumption.